RODE VideoMic Pro Microphone ไมค์ติดกล้องแบบคอนเดนเซอร์ ขนาดเล็กกะทัดรัด คุณภาพเสียงระดับมืออาชีพ ป้องกันเสียงรบกวนรอบข้างได้ดี พร้อมกันสั่นในตัว ตอบสนองความถี่ 40Hz - 20kHz สวิทช์ hi-pass filter ตัดเสียงรบกวนย่านความถี่ต่ำ สวิทช์ -10dB ป้องกันเสียงแตกจากแหล่งเสียงที่มีความดังมาก เช่น คอนเสิร์ต สวิทช์ +20dB ช่วยเพิ่มระดับเสียงสำหรับกล้อง DSLR ทำให้ลดเสียงรบกวนที่เกิดจากภาคขยายเสียงในตัวกล้อง ใช้แบตเตอรี่ 9V 

The RØDE VideoMic Pro is a true shotgun microphone designed for use with camcorders, DSLR cameras and portable audio recorders as a source of primary and reference audio.

At the heart of the VideoMic Pro is a high resolution 1/2" condenser capsule that provides broadcast-quality audio via a 3.5mm minijack connector (outputting the mono signal to both left and right channels). A super-cardioid polar pattern ensures that surrounding audio is minimised, and your recording is focused on the subject in front of the camera.

An innovative suspension system separates the VideoMic Pro capsule and electronics from its mount, providing isolation from external physical factors that may cause unwanted rumble and vibrations in the microphone. A lightweight and flexible yet robust multi-strand cable provides significantly lower noise transference than traditional audio cable while ensuring a high definition signal.

Easily accessible on the rear face of the microphone are the power, filter and level controls. In addition to the microphone's native 40Hz-20kHz response a selectable high-pass filter at 80Hz is available, which will prevent low end noise such as air conditioners and traffic from being recorded.

Below these controls are the level settings, which attenuate or boost the recorded level as required. The -10dB level attenuation (or PAD) is ideal for recording loud sound sources, such as live music, motorsport, or interviews where the subject is very close to the camera. The +20dB level boost is designed for use with DSLR cameras, allowing the user to reduce the camera's preamp level (or mic-input level), effectively reducing the amount of noise generated by the camera's comparatively low quality audio circuitry.

The microphone uses a standard sized shoe mount for on camera use, and features a 3/8" thread in the base of the mount for easy boom pole mounting.

The VideoMic pro is battery powered, and provides over 70 hours recording from a single 9V battery.

The RØDE VideoMic is designed and made in Australia, and covered by RØDE Microphones' industry leading 10 year warranty.

Acoustic Principle	Line Gradient
Active Electronics	JFET impedance converter
Capsule	0.50"
Polar Pattern
Address Type	End
Frequency Range	40Hz - 20kHz (selected HPF @ 0)
Output Impedance	200Ω
Maximum SPL	134dB SPL (@ 1kHz, 1% THD into 1KΩ load)
Maximum Output Level	6.9dBu (@ 1kHz, 1% THD into 1KΩ load)
Sensitivity	-38.0dB re 1 Volt/Pascal (12.60mV @ 94 dB SPL) +/- 2 dB @ 1kHz
Equivalent Noise Level (A-weighted)	20dB-A
Power Options
Weight	85.00gm
Dimensions	95.00mmH x 43.00mmW x 150.00mmD
Dimensions	95.00mmH x 43.00mmW x 150.00mmD
Output
Warranty	1 year with free extension to 10 years following registrationhere